503-984-1097Open until 9 pm · Open Sundays
PWR Pro Electric
Electrical Service Upgrade & Meter Base job in Rose City Park, Portland by PWR Pro Electric

Electrician in Rose City Park, Portland — Built for 1920s Bungalows

  • Licensed Oregon contractor, CCB #259813
  • Permit pulled by us
  • Written estimate before work begins
1924
Median year built
83.2%
Built before 1940
3,553
Homes here
78.8%
Owner-occupied

Recent Jobs Near Rose City Park

Real jobs our electricians finished in Rose City Park.

Electrical Service Upgrade & Meter Base in Rose City Park, Portland

Rose City Park, Portland

Electrical Service Upgrade & Meter Base

October 2026

At this Rose City Park house, the meter and service equipment on the back wall were overdue for replacement. We upgraded the service and cleaned up the equipment on the outside wall so it's safe and up to code. We're a long-time electrician for this homeowner, and we're glad to keep earning that trust.

★★★★★David H.

“PWR does an amazing job. Used them for years.”

Electrical Repair & Troubleshooting in Rose City Park, Portland

Rose City Park, Portland

Electrical Repair & Troubleshooting

September 2026

An owner of several older rental properties, one of them in Rose City Park, sends us the hard problems these houses turn up. Older rentals tend to hide wiring surprises behind the walls, so electrical troubleshooting there starts with finding the real cause, then fixing it properly instead of patching it.

★★★★★Michele M.

“Igor is the smartest, most thorough electrician I’ve ever had the pleasure of working with! In owning some older rental properties, I threw some really difficult projects at him. He treated it like “nothing but a thing!” and solved every problem efficiently, thoroughly and successfully. I would trust him with ANY electrical task!”

Finishing the Attic or Basement of a Rose City Park Bungalow? Start at the Panel

The biggest of our Portland neighborhoods, mostly single-story bungalows from before 1930 — rewiring, knob-and-tube replacement and panel upgrades for older Portland homes.

Rose City Park is the largest of the seven Portland neighborhoods on this site, with 3,553 homes, and most of them are single-story bungalows. 849 went up in the 1910s and 1,606 in the 1920s; 2,561 homes — 72% — date from before 1930. A further 814 homes, 23%, were built between 1930 and 1959, and only 172 since 1960. The median house dates to 1924 and covers about 1,646 square feet. That mid-century share is about half of Eastmoreland's, where the 1930s to 1950s houses are the largest group.

A bungalow runs every circuit through the attic or the crawlspace. That changes where the wiring goes and what it takes to reach it. For a rewire it is good news, because much of the run is accessible, and access is one of the biggest things that moves a rewire's price and timeline. For anyone finishing the attic or basement it is a warning, because the old wiring is exactly what the new rooms will be built around. The 1950s houses here are the other story: in a 1955 house the original 100-amp panel is still plausible.

83.2% of homes were built before 1940 → Knob-and-Tube Replacement
1,606 bungalows from the 1920s alone → Whole-House Rewire
Houses from 1930 to 1959, original panels plausible → Electrical Panel Replacement & Upgrade

Homes in Rose City Park — and What They Need

Built 1900–1929 — 2,561 homes, 72%

Single-story bungalows; every circuit runs through attic or crawlspace.

Built 1930–1959 — 814 homes, 23%

1950s stock where an original 100-amp panel is still plausible.

Built 1960 onward — 172 homes

A small group; 71 built since 2000.

Rose City Park Electrical Facts

Power company
Pacific Power
A panel upgrade here needs Pacific Power to disconnect and reconnect the meter; we schedule that for you.
Who inspects electrical work
Portland Permitting & Development
City of Portland inspectors check electrical work in this part of northeast Portland.
Built 1900–1929
The bungalow years
Circuits run through the attic or crawlspace, so that is where we trace the old runs first.
Built 1930–1959
The mid-century houses
An original 100-amp panel may still be in service, so check it before adding a charger or heat pump.

Why Rose City Park Homeowners Call PWR Pro Electric

Licensed Oregon electrical contractor

CCB #259813

We call Pacific Power

Disconnect and reconnect, scheduled by us

Permits pulled by us

Handled as part of the job

Oregon CCB #259813

More Jobs Near Rose City Park

Real jobs our electricians finished in and around Rose City Park.

Hot Tub Electrician in Grant Park, Portland

Grant Park, Portland

Hot Tub Electrician

September 2026

A Grant Park family got a new hot tub, and it needed its own power. We trenched a line across the yard, ran a dedicated circuit to a spa disconnect and got the tub running. Hot tubs need a GFCI-protected circuit and a disconnect within sight of the tub, and we set it up that way from the start.

★★★★★Elena H.

“Professional, knowledgeable and competent, great communication, everything done on time and as promised, reasonable prices, highly recommend.”

Aluminum Wiring Repair in Beaumont-Wilshire, Portland

Beaumont-Wilshire, Portland

Aluminum Wiring Repair

September 2026

In Beaumont-Wilshire, the old three-wire aluminum circuit feeding the electric dryer was shorting out. We retired it and ran a new 30-amp dryer line with a modern four-prong outlet, routing surface conduit through the garage attic so the walls stayed intact. The work was inspected, and old splices were moved into proper junction boxes to meet code. Aluminum wiring repair like this removes a real fire risk from an older home.

★★★★★Stephen C.

“Igor is amazing to work with. His attention to detail and drive to get the project done to spec (as well as make it look good) are great attributes. He continually went above and beyond to make sure the project was completed to code. I will absolutely work with Igor again when any electrical needs arise.”

Posted on Google
Show all 4 jobs
New Circuit & Outlet Installation in Beaumont-Wilshire, Portland

Beaumont-Wilshire, Portland

New Circuit & Outlet Installation

September 2026

This Beaumont-Wilshire homeowner wanted a new outlet in the garage for tools. We ran a new circuit from the panel in flexible metal conduit and set the box where they needed it. A dedicated circuit means no more tripped breakers when the big tools are running.

★★★★★Mikhaxl

“Igor is a very knowledgeable electrician. With his service, you’re never in the dark about what’s going on. He keeps you updated from beginning to end. Definitely recommend!”

Ceiling Fan Installation & Repair in Grant Park, Portland

Grant Park, Portland

Ceiling Fan Installation & Repair

August 2026

Over three years we have done a mix of work for one Grant Park household: rewiring, ceiling fan installations and other electrical jobs as they came up. Being the electrician a family calls back year after year is the part of this work we value most.

★★★★★Joe H.

“Igor has provided services to us for over the past three years, including electrical work, rewiring, fan installations, and other related tasks. He is punctual, dependable, and offers fair pricing. We recommend him with no reservations”

FAQ — Local Homes

Does my 1910s Rose City Park home still have knob-and-tube?
Possibly. 849 homes here were built in the 1910s, when knob-and-tube was the standard. Many were partly rewired later, so a house can have both. The attic, the crawlspace and the panel usually tell the story.
Is older wiring safe for today's loads?
Old wiring was sized for the loads of its day and has no ground. It was not designed to sit under attic insulation or to feed a space heater, a microwave and a hair dryer on one circuit. Whether your house is safe depends on its condition and what has been added — an inspection answers that.
How do I know if my panel is a Zinsco or Federal Pacific?
Open the panel door — not the cover — and read the label inside. Federal Pacific panels usually say Stab-Lok; Zinsco is printed on the label or the breakers. These are the two brands inspectors flag. If unsure, send us a photo of the label.
Is my panel ready for an EV charger?
It depends on how much of its capacity is already spoken for. A 1920s house with an updated 200-amp service often has room; a 1950s house on its original 100-amp panel often does not. We add up the loads before we say.
Why do we call Pacific Power and not PGE here?
Because PGE's own service map places the neighborhood outside PGE territory, and Oregon's utility boundary map shows Pacific Power. For a service upgrade we book the Pacific Power disconnect and reconnect ourselves.

Serving Rose City Park — Book Today

Written estimate before any work begins.

Electrical Services in Rose City Park, Portland

From a panel replacement in a house off NE Sandy Blvd to a smoke detector install near NE Fremont St, PWR Pro Electric works on every street in Rose City Park. Whether you need an EV charger along NE 57th Ave or a wiring repair by NE Tillamook St, you get a same-day walk-through and a written estimate.

Also Serving Nearby:

PWR Pro Electric LLC
Serving Rose City Park & the Portland metro
Open until 9 pm Mon–Thu and Sunday · Fri until 2 pm · Closed Saturday
503-984-1097
Oregon CCB #259813
Book a Service