Heat Pump & Mini-Split Electrician in Gresham, OR
- Circuit sized to the unit
- Works with your HVAC installer's schedule
- Written summary of the work for your records
What Our Customers Say
Can Your Gresham Panel Carry a Heat Pump?
The HVAC contractor sets the unit. A heat pump electrician runs the circuit it needs, mounts the outdoor shut-off and checks that your panel can carry it.
Before it heats anything, a heat pump is a large electrical load. The outdoor unit needs its own 240-volt circuit, sized from the label on the unit: the minimum circuit ampacity and the maximum breaker size. The air handler usually needs a circuit of its own. A shut-off has to sit within sight of the outdoor unit, so whoever services it can cut the power right there. That split is why the heat pump electrician is a separate hire: setting the equipment is the HVAC contractor's job; the circuit, the disconnect and the final connection are ours.
Then comes the panel. Swapping a gas furnace for a heat pump moves a big load onto a panel that, in Gresham, often dates from the 1970s. We add up what the house runs now plus the new equipment, and the written estimate says whether a circuit alone will do or the panel needs work first. A circuit alone does not involve PGE. If the service has to grow, PGE disconnects and reconnects the house around that work, and we book both visits.
What a Heat Pump Electrician Does Here
Equipment ratings first
Circuit size taken from the unit's label
Add up the house
Existing loads plus the new unit, on paper
Written estimate
Says whether the panel needs work first
Wire and disconnect
240-volt run, outdoor shut-off, final hookup
Inspected, then running
Signed off before the heat pump starts
The 1970s are Gresham's peak building decade at 24.8% of homes, and 53% went up 1960–89, with panels sized for the loads of their day. In the 3,491 houses from 1965–73, a heat pump electrician also checks whether the branch wiring near the panel is aluminum.
When to Call a Heat Pump Electrician
What Affects the Cost of Heat Pump Wiring in Gresham
The equipment label and the panel settle most of this job; distance and unit count do the rest.
The unit's label
Minimum circuit ampacity and maximum breaker size, printed on the unit, set the wire and breaker we install.
A run for the air handler
Most ducted systems also need a separate circuit indoors, on top of the one for the outdoor unit.
Number of outdoor units
Each one gets its own circuit and shut-off, so a two- or three-unit plan means more runs.
Distance to the pad
An outdoor unit set far from the panel needs a longer 240-volt run and more material.
A panel from the 1970s
Many panels here date from the city's peak building decade, so the load math may call for panel work first.
Aluminum near the panel
In the 3,491 houses from 1965–73, any aluminum branch circuits we find need connectors listed for aluminum.
PGE and the inspection
A circuit alone leaves PGE out; a bigger service means a PGE disconnect and reconnect, and the city inspects either way.
Every job gets a written estimate before any work starts.
Why Homeowners Here Call PWR Pro Electric
Sized from the unit's label
Wire and breaker follow the printed ratings
Timed with your HVAC contractor
Circuit ready when the unit is on its pad
1-year warranty on our work
Bonded & insured, and we pull the electrical permit
Questions Homeowners Ask
Does Energy Trust of Oregon pay for the heat pump circuit?
Will my panel need an upgrade before the heat pump goes in?
Is a ductless mini-split wired the same way as a ducted heat pump?
How long does the heat pump electrician need on site?
Book a Heat Pump Electrician in Gresham
Written estimate before any work begins.